Hello Everyone:

This week has been an awesome experience here aboard the R/V Sharpe. This week we spent several days prepping the vessel, for a search and recovery mission to reclaim the HAB CAM that was lost when it struck a shipwreck while being towed. We discovered the shipwreck to be the Bow Mariner. The Bow Mariner is a tanker ship that sank when the ethanol it was transporting exploded. The ship is 500+ feet long, and is lying in around 220 feet of water off the coast of Virginia.

The ROV technicians that the science team hired for this mission were Dennis and Kevin from the University of Connecticut. The name of the ROV is the Kraken 2. The ROV technicians took the time to show me the basic set up of the Kraken 2, and discuss with me the engineering design of the vehicle, and the routine maintenance procedures that had to be performed after each dive, as well as basic troubleshooting methods. All the electrical wiring throughout the ROV is encased in oil which does not conduct electricity, and does not compress. This particular vehicle was equipped with a hydraulic arm, pressure sensors, altimeter, lights, and several cameras showing views ahead, above, and below the unit. The ROV of course can to conformed and outfitted with many other sensors, and altered to perform a variety of task.

My duties this week consisted of making wire runs that were needed to support the ROV lab, assisting in loading the ROV and its supporting equipment, securing equipment to the deck, assist with the deployment and retrieval of the ROV, and stowing away lines and tools used for the day’s work, just to name a few.

When we arrived on station the ROV was deployed and I was allowed to watch the entire operation in the control lab with Dennis and Kevin. It was really neat to see, and a very tedious process coordinating the ROV’s movements with the ship, and the currents. To make a long story short the HAB CAM was located nose up in the wreckage, and the winch operator lowered a clip down to the ROV, which was attached to the CAM and brought to the surface. Keep in mind this whole process is not as easy as it sounds, and it took hours of tedious work to get this process done.

KG and Chip have also been working with me explaining the electrical systems aboard the R/V Sharp. Also, we have drawn up a schematic, of the winch systems throughout the vessel in order to familiarize me with the setup. The plan is to go through each system step by step as the internship moves along.

Well that is it for now, and as I am typing this up we are headed offshore with the HAB CAM, and dredge to begin the 2nd leg of the cruise. Talk to everyone latter.

Just a quick note. I have some pictures to share with everyone, but KG has not been able to locate his camera cord to allow him to upload the pictures.

Till next time,

Chris Petroff